How do you route solar cables across a roof?
In a tray or on a ladder on roof blocks, with a cover against UV light and leaves. Lift the route slightly off the roof so water drains freely and the membrane is not damaged. Where the route enters the building, it ends at a roof penetration made by the roofer.
| Requirement | Advice |
|---|---|
| Outdoors, UV | Hot-dip galvanised (HDG), tray with cover |
| No penetrations | Roof blocks 200 × 200 mm on a protection layer |
| Units and pipework | H-frame or double channel on roof blocks |
| Wind | Weight and number of blocks by calculation |
Solar mounting rail or strut?
Mounting rails from solar racking systems are a product group of their own. Strutconfigurator covers the installation around them: cable routes, frames for inverters and units, and pipework. You configure that combination in one go.
Which systems do you use on a flat roof?
The configurator covers every system below. You combine them in one configuration, with one bill of materials.
- Roof support blocks with strut channel for cable routes to the panels
- H-frames on roof blocks for inverters, condensers and air handling
- Cable trays with covers against UV and dirt
- Hot-dip galvanised channel and fixings for outdoor use
Frequently asked questions
Should a rooftop cable route have a cover?
It is advisable: a cover protects cables from UV light, dirt and falling branches. Use cables rated for outdoor use.
How many roof support blocks do you need?
That follows from the load, the channel, wind load and the compressive strength of the roof. The configurator calculates indicatively; a structural engineer confirms.