Strutconfigurator
System · cantilever arm and christmas tree

Cantilever arms: containment along the wall

Along walls, columns and in shafts, a cantilever carries the containment. A wall channel with arms, or a christmas tree with arms on both sides of one upright. The configurator works it out per arm.

Short answer

A cantilever arm is a projecting strut channel arm with a base plate, fixed to a wall, column or wall channel. Common arm lengths run from 150 to 750 mm in 41×21 and up to 1,000 mm in 41×41, in 150 mm steps. A christmas tree bracket has arms on both sides of a single upright.

Cantilever arms: containment along the wall450400Wall channel 41×41wall anchorsCantilever arm 300with gusset baseViewSideScale1:15
cantilever arm and christmas treeOwn drawing · to scale
  • Hosting Data stored in the EU · Frankfurt Stored with Neon (eu-central-1) · runs on the Cloudflare network
  • Privacy GDPR Data processing agreement available
  • System Brand-independent Public version · client version on your own range
  • Built by Built by NEXTRIQ 5.0 on Google · 22 reviews

When should you use a cantilever instead of a trapeze?

When the route runs along a wall or column, in shafts and tunnels, or where there is no room above the route for threaded rod. Cantilevers keep the containment off the floor and leave the space below clear.

What cantilever arms are there?

Arm length follows from the containment width plus room for the fixing. For heavy ladders choose a double channel.

Common cantilever arms
TypeLengths (mm)Base plate
Cantilever 41×21150 to 750130 to 133 mm high
Cantilever 41×41150 to 1,000130 to 133 mm high
Cantilever 41×82 back-to-back150 to 1,250165 to 175 mm high

Source: catalogues from three manufacturers, lengths in 150 mm steps (brand-independent standard catalogue).

What is a christmas tree bracket?

A christmas tree is one upright, of channel or threaded rod, with arms on both sides. Useful in narrow corridors and shafts: one fixing point carries two routes. In the configurator you choose 1 or 2 levels, the arm length and the upright length.

What should you watch with loads?

On a cantilever the moment at the wall counts: the load times the distance from the wall. A full ladder at the tip of a long arm puts a large moment on the anchors or the beam clamp. Public load tables for the standard 41 cantilever arm are limited, so the configurator calculates indicatively and the manufacturer confirms.

Frequently asked questions

What is the difference between a cantilever and a bracket?

In practice the same: a projecting arm that carries containment. "Cantilever arm" is the product name, "bracket" the general term.

How far apart should cantilevers be?

As far apart as trapezes: the containment manufacturer gives the permitted span. For cable tray, 1.2 to 1.5 m is a common rule of thumb.

Can a cantilever be fixed to a steel beam?

Yes, with a beam clamp or a wall channel on the flange. Beam clamps have a safe working load of about 1,000 to 4,550 N depending on the type (manufacturer data).

Next step

See your own range in 3D.

In 30 minutes we show how your installers configure, what arrives on your side and what the client version on your range involves.

Manufacturer or wholesaler

Book a demo with Ismail

You see the configurator in your own brand and we discuss your range, systems and markets.

Reply from Ismail within one working day

Installer

Configure for free

A trapeze, frame or tray with cables in a few minutes, with a bill of materials and drawing.

Enquiry goes to a supplier · reply within one working day